|
|
M_3022 |
 |
The Model 3022 is a piezoresistive silicon accelerometer. It is
packaged on a ceramic substrate with an epoxy sealed ceramic cover
and is designed for adhesive mounting. A detailed calibration
sheet provides test data and resistor compensation values for each
sensor.
资料下载 |
|
|
M_3028 |
 |
The Model 3028 is a piezoresistive silicon accelerometer. It is
packaged on a ceramic substrate with a metal bracket which can be
used to bolt the sensor to the mounting location. A detailed
calibration sheet provides test data and resistor compensation
values for each sensor.
资料下载 |
|
|
M_3031 |
 |
The Model 3031 is a piezoresistive silicon accelerometer in a
surface mount package. It is intended for high volume applications
where small size, light weight, and low cost are required. This
accelerometer consists of a micro machined silicon mass suspended
by multiple beams from a silicon frame. Piezoresistors located in
the beams change their resistance as the motion of the suspended
mass changes the strain in the beams. Silicon caps on the top and
bottom of the device are added to provide over-range stops.
资料下载 |
|
|
M_3052 |
 |
The Model 3052 is a piezoresistive silicon accelerometer with
integral temperature compensation. It is packaged on a ceramic
substrate with an epoxy sealed ceramic cover and is designed for
adhesive mounting. The accelerometer consists of a micro machined
silicon mass suspended by multiple beams from a silicon frame.
Piezoresistors located in the beams change their resistance as the
motion of the suspended mass changes the strain in the beams.
Silicon caps on the top and bottom of the device are added to
provide over-range stops.
资料下载 |
|
|
M_3058 |
 |
The Model 3058 is a piezoresistive silicon accelerometer with
integral temperature compensation. It is packaged on a ceramic
substrate with a metal bracket which can be used to bolt the
sensor to the mounting location. The accelerometer consists of a
micro machined silicon mass suspended by multiple beams from a
silicon frame. Piezoresistors located in the beams change their
resistance as the motion of the suspended mass changes the strain
in the beams.
资料下载 |
|
|
M_3140 |
 |
The Model 3140 is a high performance accelerometer intended for
instrumentation applications. The 3140 provides a fully signal
conditioned output with performance similar to traditional
instrumentation accelerometers but at a much lower cost. The
accelerometer consists of a silicon micro machined accelerometer
with signal conditioning electronics in a lightweight Valox™
housing that can be easily attached to a mounting surface.
资料下载 |
|
|
M_3145 |
 |
The Model 3145 is a general purpose performance accelerometer
intended for instrumentation applications. The 3145 provides a
fully signal conditioned output with performance similar to
traditional instrumentation accelerometers but at a much lower
cost. The accelerometer consists of a silicon micro machined
accelerometer with signal conditioning electronics in a
lightweight Valox™ housing that can be easily attached to a
mounting surface.
资料下载 |
|
|
M_3255 |
 |
The Model 3255 is a two-chip accelerometer designed for low cost
surface mount applications. The package can be mounted in one of
two orientations, allowing the measurement axis to be either
parallel or perpendicular to the mounting surface without the use
of costly brackets.
This accelerometer consists of a micro machined silicon mass
suspended by multiple beams from a silicon frame. Piezoresistors
located in the beams change their resistance as the motion of the
suspended mass changes the strain in the beams.
资料下载 |